Sharing of tips on installation and cleaning of headstock bearing

During the installation and use of bearings, the clearance between the axial and axial directions can be adjusted. The products wholesale by the manufacturer of the headstock bearings can take some measures to improve the rigidity of the bearings. The clearance specification of the bearing is the key to whether the bearing can work better. If the clearance is too small, resulting in high temperature, large clearance and large vibration, it is not easy to ensure its rotation accuracy. Too large or too small will cause damage to the bearing. Therefore, special attention should be paid to adjusting the bearing clearance when using or using. When installing the bearing, the shaft should not be inclined compared with the shell hole to avoid the stress in the contact area between the roller and the roller, so it is more likely to cause premature bearing damage. Only in some special cases, a small amount of inclination is allowed. For example, when the adjustment line between the roller and the roller bus contacts.

After all, under the influence of axial load, it will generate some additional forces. Therefore, two sets of bearings are generally installed in two supports of the shaft, so that the homonymous ends of the bearing inner and outer rings correspond to each other.

Bearing cleaning method:

1. The customized cleaning of the cartridge type head bowl bearing can be divided into fine cleaning and rough cleaning, and the metal mesh frame can be inserted at the bottom of the vessel Z.

2. When carefully cleaning non-standard bearings, slowly rotate non-standard bearings in oil and carefully. Generally, the detergent used is neutral, free of water, diesel and gasoline, and sometimes warm lye is used as required. No matter which cleaning fluid is used, it must always be considered and kept clean.

3. When rough cleaning the bearing, use a brush to clean the grease and adhesive in the oil. At this time, if the bearing rotates in the oil, pay attention to the damage to the rotating surface caused by foreign matters.

Generally, when you have to bear the main axial and axial cooperative loads of the axial load of the customized products of motorcycle head bowl bearings, select non-standard tapered bearings. Some special non-standard tapered bearings can bear axial cooperative loads, but they are generally not suitable for bearing some simple axial loads. This can limit the axial deviation of the angle on the shaft, so non-standard bearings can be used as bearings with one-way axial positioning. This structure can be separated and installed on the inner ring and the outer ring. It can also be easily exchanged, installed and disassembled externally - small non-standard bearings.